|
Title: What is a BROADBAND ? Post by: Shashank Asthana on December 04, 2006, 11:11:16 AM What is a BROADBAND ?
Broadband in telecommunications is a term which refers to a signaling method which includes or handles a relatively wide range of frequencies which may be divided into channels or frequency bins. Broadband is always a relative term, understood according to its context. The wider the bandwidth, the more information can be carried. In radio, for example, a very narrowband signal will carry Morse code; a broader band will carry speech; a yet broader band is required to carry music without losing the high audio frequenci es required for realistic sound reproduction. A television antenna described as "normal" may be capable of receiving a certain range of channels; one described as "broadband" will receive more channels. In data communications a modem will transmit a bandwidth of 64 kilobits per seconds (kbit/s) over a telephone line; over the same telephone line a bandwidth of several megabits per second can be handled by ADSL, which is described as broadband (relative to a modem over a telephone line, although much less than can be achieved over a fibre optic circuit, for example). Broadband in data communications may have the same meaning as above, so that data transmission over a fibre optic cable would be referred to as broadband as compared to a telephone modem operating at 600 bits per second. However, broadband in data communications is frequently used in a more technical sense to refer to data transmission where multiple pieces of data are sent simultaneously to increase the effective rate of transmission, regardless of actual data rate. In network engineering this term is used for methods where two or more signals share a medium. Various forms of Digital Subscriber Line service are broadband in the sense that digital information is sent over one channel and voice over another channel sharing a single pair of wires. Analog modems operating at speeds greater than 600 bit/s are technically broadband. They obtain higher effective transmission rates by using multiple channels with the rate on each channel limited to 600 baud. For example, a 2400 bit/s modem uses four 600 baud channels (see baud). This is in contrast to a baseband transmission where one type of signal uses a medium's full bandwidth such as 100BASE-T Ethernet. Fibre optic cables do not work properly. Multiplexing Communications may utilise a number of distinct physical channels simultaneously; this is multiplexing for multiple access. Such channels may be distinguished by being separated from each other in time (time division multiplexing or TDMA), in carrier frequency (frequency division multiplexing (FDMA) or wavelength division multiplexing (WDM)), or in access method (code division multiplexing or CDM). Each channel that takes part in such a multiplexing exercise is by definition narrowband (because it is not utilising the whole bandwidth of the medium), whereas the whole set of channels taken together and utilised for the same communication could be described as broadband. Title: Re: What is a BROADBAND ? Post by: Mark David on February 18, 2007, 11:16:41 PM A communication network in which the bandwidth can be divided and shared by multiple simultaneous signals (voice, data, video). The network can carry multiple signals by dividing the total capacity of the medium into multiple, independent bandwidth channels, where each channel operates only on a specific range of frequencies. The term broadband is widely used to describe internet connections with download speeds which are faster than dial-up, including DSL services, such as Verizon and SBC, cable modem services, such as Roadrunner (a division of Time Warner) and Comcast, as well as satellite connections.
Related terms: ISP, DSL, ADSL, cable modem, satellite connection, high speed internet access, internet service provider, broadband connection, broadband service provider |